Program your PC5740 by UTStarcom

Last Updated: Nov 18, 2013

There are three parts to programming and activating your device:

  • Installing the Sprint Connection Manager
  • Installing the UTStarcom PC5740 drivers
  • Card activation and provisioning

Installing the Sprint Connection Manager

NOTE: Users of Windows 2000 need to be logged in with administrative privileges to install the Sprint Connection Manager software.

NOTE: Users of Windows XP may insert the card prior to installing the software. They may also require administrative privileges, depending on your XP installation.

To install the Sprint Connection Manager:

  1. Delete or uninstall any previously existing modem or dialer software from the computer.
  2. Quit all open applications before you begin installation.
  3. Insert the installation CD into your CD-ROM drive. The Sprint Connection Manager software automatically determines your computer's operating system. The CD should auto-start and will display a menu. NOTE: If the CD does not auto-start, select Start > Run, and enter d:launch.exe (where d is the letter of your CD-ROM drive).
  4. From the CD start-up window, select Install Sprint Connection Manager, and click Next to launch the InstallShield Wizard.
  5. In the License Agreement window, click I accept the terms to accept the agreement and click Next to proceed with the installation.
  6. Click Next to install the software to the default destination folder (recommended). NOTE: If you need to install the software to a different folder, click Change and select an alternate installation destination.
  7. Select Complete to install all features and click Next.
  8. Click Install to complete the installation and launch the Sprint Connection Manager.
  9. Click Finish to exit the wizard.
  10. You will receive a message about restarting the computer, click Yes. NOTE: For Windows 2000, your computer may need to be manually restarted. To do so, go to Start > Shutdown > Restart.
  11. Wait for your computer to restart.

Installing the PC5740 by UTStarcom drivers

To install the PC5740 by UTStarcom drivers:

  1. Insert the Sprint connection card PC5740 into the Type II PC Card slot. Windows will detect the new hardware (Sprint connection card) and will install the necessary drivers.
  2. The Add New Hardware Wizard or Found New Hardware Wizard will launch depending on your operating system.
  3. Follow the onscreen prompts to allow the wizard to install the drivers.
  4. When notified that the installation is complete, click OK.
  5. If you purchased a pre-activated Sprint connection card, the card is ready for use. Otherwise, continue to activation.

Card activation and provisioning

To activate and provision your card:

  1. After the software and driver installations are complete, the software will detect the characteristics of the card. NOTE: If you close the activation wizard before finishing the card activation and provisioning process, the Activation Wizard can be found at Menu > Settings > Sprint Vision-UTStarcom and Activation Wizard from within the Connection Manager.
  2. Using the mouse, select and click Next to proceed with the activation process. The windows will describe the process.
  3. Enter the MDN and MSID in the spaces provided and click Next.
  4. A confirmation box will display. Click Yes if the information is correct.
  5. Click Finish to complete the activation process.
  6. Expect to wait up to 4 hours for your device to begin working.

NOTE: Provisioning will start immediately after activation. Expect to wait up to 4 hours for your device to begin working. If the provisioning process does not complete within 5 hours, contact us.

Average User Rating
(135 ratings)

My rating

Contact us

Find a store

Recently Viewed