Program your Sprint 3G/4G Plug-in-Connect USB U602 by Franklin Wireless

Last Updated: Nov 16, 2013

To install and run your Sprint 3G/4G Plug-in-Connect USB U602 by Franklin Wireless and accompanying software, your system requires:

  • Windows® XP (Service Pack 3 or later), Vista, or 7
  • Interface: USB port

Hands-Free Programming

As long as your data plan subscription and ESN have been established in the Sprint billing system, you can simply follow these instructions to install the software and click Yes when prompted to activate.

Note: Installation and activation may require you to be logged in with administrative privileges.

  1. Connect the USB modem to the computer’s USB port.
    • Windows will detect the device and automatically install the necessary device drivers.
    • The LED indicator is lit on the USB device. \
    • Windows XP (service pack 3 required) ONLY you will see a Sprint Dual Mode Setup window. Click Install and then Close when the install completes.
  2. Wait to proceed until the system tray displays Your devices are ready to use or Your new hardware is installed and ready to use.
  3. The device will automatically connect the Sprint network after activation is complete and the LEDs will begin blinking green or blue, depending on a 3G or 4G connection.

Average User Rating
(8 ratings)

My rating

Contact us

Find a store

Recently Viewed